Engineering, 10.09.2019 20:30 golderhadashaowtatz

Afreight train and a passenger train share the same rail track. the freight train leaves station a at 8: 00 a. m. the train travels at a speed of 45 km/h for the first 10 minutes and then continues to travel at a speed of 60 km/h. at 8: 35 a. m., the passenger train leaves station a. the pas¬senger train travels first at a speed of 75 km/h for 5 minutes and then continues to travel at a speed of 105 km/h. determine the location of the siding where the freight train will have to be parked to allow the faster passenger train to pass through. as a safety precaution, it is determined that the time headway between the two trains should not be allowed to fall below 5 minutes.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Afreight train and a passenger train share the same rail track. the freight train leaves station a a...

Questions

SAT, 04.12.2020 06:30

MY LAST FREE POINTS GIVE AWAY FOR TONIGHT please say thank you...