Engineering, 03.09.2019 03:30 jayzeptor

Apump is used to transfer h2o from the surface of a lake into a tank where pressure is maintained at 350 kpa. the pump operates in steady flow with an efficiency of 0.6 and has an iniet volume flow rate of 0.5m^3/s. making good engineering assumptions, do the following: a) calculate the actual power required to drive the pump. b) determine the volume flow rate at the discharge of the pump. c) show this process on a t-s diagram including the saturation curve.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

You know the right answer?

Apump is used to transfer h2o from the surface of a lake into a tank where pressure is maintained at...

Questions

Engineering, 07.08.2019 19:10

What factors or parameters in the fin dictates its efficiency. if you want to improve fin efficiency, clearly describe how you will achieve it....

Engineering, 07.08.2019 19:10

What is the maximum volume flow rate, in m^3/hr, of water at 15.6°c a 10-cm diameter pipe can carry such that the flow will be laminar?...

Engineering, 07.08.2019 19:10

What is a planck distribution and how is it used to solve for black body radiation problems?...

Engineering, 07.08.2019 19:10