Engineering, 03.09.2019 00:30 abdalla46

The company flew an aircraft to mobile alabama for maintenance, repair, and overhaul (mro) service. the aircraft basic weight was 2886 and had a moment calculated at 101673.78. while in the hanger the aircraft was required to be modified. two 15 pound seats located at station +71 were required to be removed. a new cabinet weighing 97 pounds was installed in place of the seats (at station +71). also at station +71, an upgraded seat weighing 20 pounds was installed. as part of the new modification, new radio equipment was installed at station +94 weighing 30 pounds. calculate the new weight of the aircraft and cg of the aircraft after modification:

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

Answer

You know the right answer?

The company flew an aircraft to mobile alabama for maintenance, repair, and overhaul (mro) service....

Questions