Engineering, 30.08.2019 04:10 alondraalfaro06
Afull journal bearing is required for a shaft with the following specifications: nominal diameter 40 mm diametric clearance 60 µm rotational speed (rpm) 1450 load on the bearing 2100 n inlet temperature of the lubricant 60°c bearing length to diameter 1. assume the lubricant is sae 10 and an initial temperature change is 15°c. a)-determine the overall temperature rise in the bearing. b)-determine the flow rate of the lubricant required.
Answers: 2
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Afull journal bearing is required for a shaft with the following specifications: nominal diameter 4...
Spanish, 20.04.2020 19:46
English, 20.04.2020 19:46
Biology, 20.04.2020 19:46
English, 20.04.2020 19:46
Mathematics, 20.04.2020 19:46
English, 20.04.2020 19:46
Mathematics, 20.04.2020 19:46
Mathematics, 20.04.2020 19:46