Engineering, 30.08.2019 00:20 aguerobia
Copper tubes are produced by horizontal true centrifugal casting. the tube 2.4 lengths 2.0 m, outside diameter 16.0 cm, and inside diameter 15.0 cm. if the rotational speed of the pipe 900 rev/min, determine the g-factor.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Copper tubes are produced by horizontal true centrifugal casting. the tube 2.4 lengths 2.0 m, outsid...
Questions
Computers and Technology, 12.03.2020 22:00
English, 12.03.2020 22:00
