Engineering, 29.08.2019 18:30 bigmouth804
Asolid round bar with diameter of 50-mm has a groove cut to a diameter of 45-mm, with a radius of 2.5-mm. the bar is not rotating. the bar is loaded with a repeated bending load that causes the bending moment at the groove to fluctuate between 0 and 2825 n-m. the bar is hot-rolled aisi 1095, but the groove has been machined. a) determine the factor of safety for fatigue based on infinite life and b) determinethe factor of safety for yielding.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
Asolid round bar with diameter of 50-mm has a groove cut to a diameter of 45-mm, with a radius of 2....
Questions
Chemistry, 18.11.2020 18:50
Mathematics, 18.11.2020 18:50
Mathematics, 18.11.2020 18:50
Mathematics, 18.11.2020 18:50
English, 18.11.2020 18:50
Health, 18.11.2020 18:50
Mathematics, 18.11.2020 18:50
Social Studies, 18.11.2020 18:50
