Engineering, 27.08.2019 20:20 mxhx

Design a tower intake to be placed in a reservoir in a warm climate. provide the minimum number of ports. the design conditions are: summer design flow rate = 38,000 m^3/d maximum reservoir elevation = 499.0 m minimum reservoir elevation = 480.7 m lake bottom elevation = 477.7 m bar rack bars: 1 cm diameter: 8 cm between bars specify the following: number and location of intake ports spacing of the ports depth of lowest port depth of top port dimensions of a port provide a sketch of the following: intake tower with elevations of ports, reservoir elevations, and lake bottom elevation

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

You know the right answer?

Design a tower intake to be placed in a reservoir in a warm climate. provide the minimum number of p...

Questions