Engineering, 22.08.2019 01:20 Gghbhgy4809

Asteam power plant operates on a kpa in the boiler and condenser, respectively. due to the metallurgic limits in fabrication of the turbine blades, the maximum temperature in the cycle is not to exceed 500 °c. the isentropic efficiency is 85% for both the turbine and the pump. simple nonideal rankine cycle between the pressure limits of 10 mpa and 10 (a) show the cycle on a t-s diagram with respect to the saturation lines. (b) solve for the rate of work done by the compressor on the steam flow (c) determine the rate of heat input and output in the boiler and condenser, respectively, when the power plant operates at its maximum capacity (d) determine the thermal efficiency of the cycle. (e) what is the required mass flow rate of the steam through the cycle to generate 210 mw in the power plant?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

You know the right answer?

Asteam power plant operates on a kpa in the boiler and condenser, respectively. due to the metallurg...

Questions