Engineering, 20.08.2019 20:30 serafimharmane4944

Acircular rod is attached perpendicular to a plane wall. the rod is 0.5 cm in diameter and is 10 cm long. it is made of metal with a thermal conductivity k = 100 w/m-k. the temperature of the wall to which the rod is attached is 130 c. air at a temperature of 36 c is blown across the rod with a velocity of 40 m/s. find: (a) calculate the heat transfer coefficient for the rod assuming that it can be treated as a cylinder in crossflow. use air properties at 350 k. (b) calculate the rate of heat loss from the fin.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

Engineering, 06.07.2019 02:30

An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?

Answers: 3

Answer

You know the right answer?

Acircular rod is attached perpendicular to a plane wall. the rod is 0.5 cm in diameter and is 10 cm...

Questions