Engineering, 20.08.2019 20:30 sierracupcake0220

Atransformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10-cm6.2-cm wide polished aluminum heat sink (emissivity 0.03) to its top surface. the heat sink has seven fins, which are 5 mm high, 2 mm thick, and 10 cm long. a fan blows air at 25â°c parallel to the passages between the fins. the heat sink is to dissipate 12 w of heat and the base temperature of the heat sink is not to exceed 60â°c. assuming the fins and the base plate to be nearly isothermal and the radiation heat transfer to be negligible, determine the minimum free-stream velocity the fan needs to supply to avoid overheating.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

Answer

Engineering, 06.07.2019 02:30

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

1kg of water contained in a piston-cylinder assembly undergoes two processes in series from an initial state where the pressure is 3.0 bar and the temperature is 150°c process 1-2: the water is compressed isothermally to a volume of 0.25 m^3 with 120 kj of work being done to the system. process 2-3: the water is heated at constant volume to a final pressure of 10 bar. a. find the change in internal energy for the system. b. calculate the amount of heat transferred, in kj. c. sketch both processes on a t-v diagram. (196.33 kj/kg, 76.33 kj)

Answers: 1

Answer

You know the right answer?

Atransformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10-cm6.2-...

Questions