subject
Engineering, 20.08.2019 18:20 stormserena

Acomputer terminal room contains 125 computers with a power consumption of 130w. the room is well-insulated so that only 25% of the energy generated by the computers and their operators is dissipated through the walls. the room is 15 x 40 m with a 2.5m high ceiling and the ventilation system changes 0.9m/s resulting in a net energy flow 20kj/m. calculate the temperature of the air in the room at 10am if all of the computers are used continuously by operators with a metabolic output 85w from 9am when the temperature was 18°c. assume the specific gas constant and specific heat capacity for air are 287 j/kg. k and 1.005 kj/kg. k respectively and that atmospheric pressure is 101bar.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Acomputer terminal room contains 125 computers with a power consumption of 130w. the room is well-in...
Questions
question
Biology, 23.12.2019 23:31
Questions on the website: 13722363