Engineering, 20.08.2019 18:10 Atromity
When molding a large 1 mm thick, 300 mm by 20 mm, polystyrene ruler it is likely to have a 6k temperature imbalance between the mold halves. the thermal expansion of ps is b = 80um/m/k. the modulus for a characteristic demolding time is 1 gpa. estimate the amount of warpage for a 6k thermal mold imbalance. where are the maximum compressive residual stresses located in the ruler?
Answers: 3
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
When molding a large 1 mm thick, 300 mm by 20 mm, polystyrene ruler it is likely to have a 6k temper...
English, 03.02.2020 19:48
History, 03.02.2020 19:48
Social Studies, 03.02.2020 19:48
Business, 03.02.2020 19:48
Chemistry, 03.02.2020 19:48