subject
Engineering, 20.08.2019 17:10 madisongibson62

Water is the working fluid in an ideal regenerative rankine cycle. superheated vapor enters the turbine at 10 mpa, 4808c, and the condenser pressure is 6 kpa. steam expands through the first-stage turbine to 0.7 mpa where some of the steam is extracted and diverted to an open feedwater heater operating at 0.7 mpa. the remaining steam expands through the second-stage turbine to the condenser pressure of 6 kpa. saturated liquid exits the feedwater heater at 0.7 mpa. determine for the cycle: (a) the heat addition, in kj per kg of the steam entering the first-stage turbine.(b) the thermal efficiency.(c) the heat transfer from the working fluid passing through the condenser to the cooling water, in kj per kg of steam entering the first-stage turbine. for the cycle of this problem, reconsider the analysis assuming the pump and each turbine stage have an isentropic efficiency of 80%. answer the same questions as in problem above for the modified cycle.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
You know the right answer?
Water is the working fluid in an ideal regenerative rankine cycle. superheated vapor enters the turb...
Questions
question
History, 20.11.2019 15:31
Questions on the website: 13722367