Engineering, 07.08.2019 17:20 jecorie
There is a 4-cylinder, 4-stroke internal combustion engine with a stroke of 0.08m and a bore of 0.2m. there is a clearance volume that is 14% of the cylinder volume at bottom dead center. the crankshaft rotates at 2000rpm. the process in each cylinder is modeled as an air-standard otto cycle with a pressure p = 200kpa and temperature t = 400k at the start of compression. the max temp. in the cycle is is 3000k. now, answer the following questions: 1. draw the p-v diagram of the cycle and label the temperatures and pressures given. 2. how much heat (in kj/kg) is absorbed in each cycle of one cylinder? 3. how much heat (in kj/kg) is rejected in each cycle for one cylinder? 4. what is the net work (in kj/kg) delivered in each cycle of one cylinder? ignore changes in potential or kinetic energy. 5. what is the net work (in kj) produced in each cycle for 1 cylinder? 6. what is the net power (in horsepower) generated by this engine?
Answers: 3
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
There is a 4-cylinder, 4-stroke internal combustion engine with a stroke of 0.08m and a bore of 0.2m...
Computers and Technology, 23.09.2019 03:50
Mathematics, 23.09.2019 03:50
Mathematics, 23.09.2019 03:50
Computers and Technology, 23.09.2019 03:50
Mathematics, 23.09.2019 03:50
Health, 23.09.2019 03:50
Mathematics, 23.09.2019 03:50
Computers and Technology, 23.09.2019 03:50