Engineering, 26.07.2019 19:10 april861

You are designing a steam power plant based on the rankine cycle, to deliver a net power output of 250 mw. the turbine inlet state is specified as 8 mpa and 500°c, and the pump inlet state is specified as saturated liquid at 20 kpa. the isentropic efficiency of the turbine is 90% and the pump is approximately isentropic. (a) sketch the layout of the plant and a t–s diagram for the cycle. (b) determine the thermal efficiency of the cycle. (c) determine the required mass flow rate of steam. (d) to reduce the cost of the boiler, it’s proposed to reduce boiler pressure to 6 mpa. the other information specified above will not change. sketch a new t–s diagram showing both the original and modified cycles. discuss the impact of the proposed change on the performance of the power plant.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

You know the right answer?

You are designing a steam power plant based on the rankine cycle, to deliver a net power output of 2...

Questions