Engineering, 26.07.2019 19:10 MayFlowers
Why might peck drilling be used instead of standard drilling with a 0.25" diameter hole which is 3 inches deep on a aluminum part? a. to save time b. to reduce temperature and tool wear of the bit c. to keep the flutes fully engaged at all times and increase chip length
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 19:10
What is a monomer? how do they form a ploymer from the view point of chemical bonding?
Answers: 1
You know the right answer?
Why might peck drilling be used instead of standard drilling with a 0.25" diameter hole which is 3 i...
Questions
Mathematics, 03.06.2021 21:50
Mathematics, 03.06.2021 21:50
Mathematics, 03.06.2021 21:50
Mathematics, 03.06.2021 21:50
Biology, 03.06.2021 21:50
Mathematics, 03.06.2021 21:50
Physics, 03.06.2021 21:50
Mathematics, 03.06.2021 21:50
