Engineering, 26.07.2019 18:10 lizzy2951
A20 mm deep slot is being milled in a block of aluminum with k 850 n/mm2. the tool is 25 mm in diameter, and has 2 teeth. it is rotating at 14,728 rpm, and the chip load (feed per tooth) is 0.1 mm. how much power is consumed in kw?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
You know the right answer?
A20 mm deep slot is being milled in a block of aluminum with k 850 n/mm2. the tool is 25 mm in diame...
Questions
Mathematics, 07.12.2019 05:31
Mathematics, 07.12.2019 05:31
Mathematics, 07.12.2019 05:31
