Engineering, 26.07.2019 17:10 taliyahjhonson1
What are the general principle of dfa? what are the steps to minimizing the number of parts for an assembly? chart the steps followed during minimum parts assessment
Answers: 1
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
What are the general principle of dfa? what are the steps to minimizing the number of parts for an...
Mathematics, 18.10.2019 22:30
History, 18.10.2019 22:30
Social Studies, 18.10.2019 22:30
History, 18.10.2019 22:30
History, 18.10.2019 22:30
English, 18.10.2019 22:30
Mathematics, 18.10.2019 22:30
Social Studies, 18.10.2019 22:30
Physics, 18.10.2019 22:30
History, 18.10.2019 22:30
Biology, 18.10.2019 22:30