Engineering, 26.07.2019 17:10 sandram74691

Asteam power plant operates on the ideal reheat rankine cycle. steam enters the high pressure turbine at 6 mpa and 500°c and leaves as saturated vapour. steam is then reheated to 400°c before it expands to a pressure of 10 kpa. heat is transferred to steam in the boiler at a rate of 6 x 104 kw. steam is cooled in the condenser by cooling water from a nearby river, which enters the condenser at 7°c. show the process cycle on t-s diagram with respect to saturation lines. determine a) the pressure at which the reheating takes place b) the net power output and thermal efficiency c) the minimum mass flow rate of the cooling water required

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

You know the right answer?

Asteam power plant operates on the ideal reheat rankine cycle. steam enters the high pressure turbin...

Questions