Engineering, 26.07.2019 17:10 jazare05

Aship has a length of 150 m and wetted area of 3000 m2. a model of this ship 5m in a ship has a length of 150 m and wetted area of 3000 m2. a model of this ship 5m in surface has skin resistance of 49.05 n/m2 at a velocity of 3 m/s and the velocity index is 1.85. the corresponding values for the model surface towed in fresh water are respectively 16.38 n/m2, 3m/s and 1.90. calculate : (i) the corresponding speed of ship (ii) the shaft power required to propel the ship at this speed through sea water (p =1030 kg/m3). take the propeller efficiency as 75%.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

You know the right answer?

Aship has a length of 150 m and wetted area of 3000 m2. a model of this ship 5m in a ship has a leng...

Questions