Engineering, 20.07.2019 00:10 aiueo946
General purpose acme threads: a. bear at the flanks b. bear at the major diameter c. have the same clearance at the root and the flank d. generally have very poor finishes so fits are not important
Answers: 3
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
General purpose acme threads: a. bear at the flanks b. bear at the major diameter c. have the same...
Mathematics, 22.02.2020 00:46
Geography, 22.02.2020 00:46