subject
Engineering, 19.07.2019 20:30 derrickgatson48

Agas in a piston-cylinder asscmbly undcrgocs a process for which the rclationship bctwcen pressurc and volumc is pv^2=constant the initial pressurc is 1 bar, the initial volume is 0.4 m^3, and the final pressure is 9 bar. determine the work for the process, in kj constant.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
Agas in a piston-cylinder asscmbly undcrgocs a process for which the rclationship bctwcen pressurc a...
Questions
question
Mathematics, 03.03.2022 14:00
question
Mathematics, 03.03.2022 14:00
question
Biology, 03.03.2022 14:00
Questions on the website: 13722363