Engineering, 19.07.2019 20:30 mihirkantighosh

Afunctional gauge is to be made to test a hole on a plate. the hole is supposed to be 1 in to 1.2 in diameter, and perpendicular to the base of the plate by no more than 0.05 in (diametral perpendicularity tolerance) at maximum material condition. what should the diameter of the go and the no go pins be? select the appropriate answer below a. go pin diameter 0.95 in, no go pin diameter 1.45 in b. go pin diameter 1.0 in, no go pin diameter 1.2 in. c. go pin diameter 12 in, no go pin diameter 1.0in. d. go pin diameter 1.45 in, no go pin diameter 0.95 in. e. none of the above.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

Answer

You know the right answer?

Afunctional gauge is to be made to test a hole on a plate. the hole is supposed to be 1 in to 1.2 in...

Questions