Engineering, 18.07.2019 03:20 Anderson0300
Determine the lubrication parameters with u=0.03350 pa. s, n =600rpm, 20mm, l=40 the average oil film temperature in oil bath and moving air condition and ambient temperature 30°c, use at least 3 iterations. state whether you should change the oil. what happens if you instead use sae 70 at 80°c with the shaft still rotating at the same n? compare each values of each parameter.
Answers: 3
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
Determine the lubrication parameters with u=0.03350 pa. s, n =600rpm, 20mm, l=40 the average oil fil...
Health, 03.05.2021 07:00
Mathematics, 03.05.2021 07:00
Mathematics, 03.05.2021 07:00
Mathematics, 03.05.2021 07:00
Computers and Technology, 03.05.2021 07:00
Geography, 03.05.2021 07:00
Geography, 03.05.2021 07:00
Mathematics, 03.05.2021 07:00
History, 03.05.2021 07:00
Mathematics, 03.05.2021 07:00
Mathematics, 03.05.2021 07:00