Engineering, 12.07.2019 22:30 artursino

Asteel bar 100 mm long and having a square cross section of 20 mm on an edge is pulled in tension with a variable load similar to a tensile test. if the bar started its plastic deformation when the load was 90 n, at which the bar elongated 1 mm. in addition, the bar started necking at 200n, at which the elongation was measured to be 3 mm. calculate the following mechanical parameters: a)- yield strength b)-young's modulus of elasticity c)-engineering tensile strength d)-strain-hardening coefficientstrength coefficient

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

Asteel bar 100 mm long and having a square cross section of 20 mm on an edge is pulled in tension wi...

Questions