Engineering, 11.07.2019 04:30 dondre54
Particular machine part is subjected in service to a maximum load of 10 kn. with the thought of providing a safety factor of 1.5, it is designed to withstand a load of 15 kn. if the maximum load encountered in various applications is normally distributed with a standard eviation of 2 kn, and if part strength is normally distributed with a standard deviation of 1.5 kn, what failure percentage would be expected in service?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
Particular machine part is subjected in service to a maximum load of 10 kn. with the thought of prov...
Questions
English, 14.09.2019 06:10
Biology, 14.09.2019 06:10
Social Studies, 14.09.2019 06:10
Engineering, 14.09.2019 06:10
