Engineering, 11.07.2019 03:10 sonnyboi2305
An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure difference between the pressure tapping points is 35 kn/m2. the flow rate of water through the meter is obtained by measuring the times required to collect a certain quantity of water in a tank and such measurements gave an average quantity of 580 litres of water collected in 2 min. determine the coefficient of discharge of the meter.
Answers: 2
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure dif...
Mathematics, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
Physics, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
History, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
Mathematics, 05.02.2021 04:50
Health, 05.02.2021 04:50