Engineering, 11.07.2019 01:30 TJxx187
Grain boundaries are: a)- point defects. b) two dimensional defects. c)- line defects. d)- none of the above
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
Engineering, 06.07.2019 04:20
Derive the 2-d finite difference equation for a uniform grid for a node: a) at a plane surface with a uniform heat flux b) at an internal corner with convection
Answers: 1
Grain boundaries are: a)- point defects. b) two dimensional defects. c)- line defects. d)- none of...
Mathematics, 05.02.2021 20:30
Mathematics, 05.02.2021 20:30
Mathematics, 05.02.2021 20:30
English, 05.02.2021 20:30
Mathematics, 05.02.2021 20:30
History, 05.02.2021 20:30
Mathematics, 05.02.2021 20:30
History, 05.02.2021 20:30
Medicine, 05.02.2021 20:30
Chemistry, 05.02.2021 20:30
Mathematics, 05.02.2021 20:30