Engineering, 11.07.2019 00:40 annafellows
Alow-carbon steel was found to follow o= (717 mpa)e^0.234. if the initial diameter was 12.8 mm and was reached duing the tensile test of this steel. 4, the diameter at fracture was 9.27 mm, calculate the maximum tensile load (kn) that during the tensile test of this steel.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
Alow-carbon steel was found to follow o= (717 mpa)e^0.234. if the initial diameter was 12.8 mm and w...
Questions
Mathematics, 24.11.2020 17:30
Spanish, 24.11.2020 17:30
English, 24.11.2020 17:30
Social Studies, 24.11.2020 17:30
Mathematics, 24.11.2020 17:30
Mathematics, 24.11.2020 17:30
Social Studies, 24.11.2020 17:30
Mathematics, 24.11.2020 17:30
History, 24.11.2020 17:30
Mathematics, 24.11.2020 17:30
Physics, 24.11.2020 17:30
Mathematics, 24.11.2020 17:30
English, 24.11.2020 17:30
Spanish, 24.11.2020 17:30
