you need to find the text string new haven in 100 documents in a folder structure on a linux server. which command would you use

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

Why might you choose to create a functional resume