subject

Question 14 1 pts
Below is a small segment of code that is supposed to switch the initial values of X and Y
in a program
Line 1: X - 4
Line 2: Y 2
Line 3: X Y
Line 4 AY
Line 5: Y X
Line 6: X A
Line 77 A
Which two lines of code need to be removed in order for the code to function properly?


Question 14

1 pts
Below is a small segment of code that is supposed to switch the initial values

ansver
Answers: 3

Another question on Computers and Technology

question
Computers and Technology, 23.06.2019 01:30
Jason works as an accountant in a department store. he needs to keep a daily record of all the invoices issued by the store. which file naming convention would him the most? a)give the file a unique name b)name the file in yymmdd format c)use descriptive name while naming the files d)use capital letters while naming the file
Answers: 3
question
Computers and Technology, 23.06.2019 03:50
Q-1 which of the following can exist as cloud-based it resources? a. physical serverb. virtual serverc. software programd. network device
Answers: 1
question
Computers and Technology, 23.06.2019 15:30
Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to
Answers: 2
question
Computers and Technology, 24.06.2019 13:30
Write a program that uses a two-dimensional array to store the highest and lowest temperatures for each month of the year. the program should output the average high, average low, and the highest and lowest temper- atures for the year. your program must consist of the following functions: a. function getdata: this function reads and stores data in the two- dimensional array. b. function averagehigh: this function calculates and returns the average high temperature for the year. c. function averagelow: this function calculates and returns the aver- age low temperature for the year. d. function indexhightemp: this function returns the index of the highest high temperature in the array. e. function indexlowtemp: this function retur
Answers: 3
You know the right answer?
Question 14 1 pts
Below is a small segment of code that is supposed to switch the initial va...
Questions
question
English, 13.12.2021 19:30
Questions on the website: 13722363