A selection sort algorithm for a one-dimensional array has the following steps:a) The smallest value in the array is found. b) It is swapped with the value in the first position of the array. c) The above steps are repeated for the rest of the array starting at the second position andadvancing each time. Eventually the entire array is divided into two parts: the sub-array of items already sorted which is built up from left to right and is found at the beginning, and the sub-array of items remaining to be sorted, occupying the remainder of the array. Write a C program that sorts an array of 10 integers using this algorithm.

Problems: 1. using textbooks, reference books, and internet as your source of research, draw the following microprocessor microarchitectures i. intel 8086 ii. motorola 68000 i atmel atmega32 iv. mips single cycle v. arm cortex-m3 write an hdl module for a hexadecimal seven-segment display decoder. the input is 4-bit binary representing a hex number (0-f), and the output is 8-bit seven segment display bits (a-h). thus, the decoder must handle the digits 10 - 15 to display a-f respectively, in addition to 0-9 numbers. 2. design a 4-bit left and right rotator (both outputs). first sketch schematic diagrams of your design. then implement your design using hdl coding. 3. 4. design a modified priority encoder that receives an 8-bit input, a7: 0 and produces a 3-bit output, y2o. y indicates the most significant bit of the input that is true. y should be 0 if none of the inputs are true. give a simplified boolean equation, sketch a schematic, and write an hdl code. 5.write an 8: 1 multiplexer module called mux8 with selection inputs s, data input d, and data output y. data input (d) and data output (v) are 32-bit wide

Today is the anniversary of me being on yet, i don't need it anymore! here's a picture of my dog wearing a bowtie! my question is, how do i delete my account?

Technician a says that with self-adjusting clutch systems, the release bearing constantly rotates. technician b says that the ball bearing portion of the release bearing should be lubricated with high-temperature grease during routine maintenance. which technician is correct?