Critical Thinking Questions 1.Can a syntax error occur in a block-based code? Why or why not?
2.What are some strategies that you can use when you debug a program?
3.How would you describe the difference between a syntax error and a logic error?
4.What are some real-life situations that require a program that is iterative? Include at 5.least three examples in your answer.
6.How would you describe the relationship between blocks of code and commands?

When you type the pwd command, you notice that your current location on the linux filesystem is the /usr/local directory. answer the following questions, assuming that your current directory is /usr/local for each question. a. which command could you use to change to the /usr directory using an absolute pathname? b. which command could you use to change to the /usr directory using a relative pathname? c. which command could you use to change to the /usr/local/share/info directory using an absolute pathname? d. which command could you use to change to the /usr/local/share/info directory using a relative pathname? e. which command could you use to change to the /etc directory using an absolute pathname? f. which command could you use to change to the /etc directory using a relative pathname?

Write an essay on online collaboration, how to do it, the challenges, resolving the challenges, and consider whether the risks are greater than rewards. ( need )

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to