Computers and Technology, 21.03.2021 05:40 tasnimabdallah971

CSM Tech Publishing has expanded its network from one subnet to two subnets and is putting 200 computers on the new subnet with plans for adding up to 100 more computers over the next few years. Currently, it's using DHCP for the existing subnet and has a scope configured with start address 172.16.1.1 and end address 172.16.1.200 with a prefix length of 24. The DHCP server is in the main distribution facility where the router is placed to route between the subnets. The current DHCP server runs Windows Server 2016, is performing well, and has plenty of unused computing resources (CPU, memory, and so forth). You need to configure DHCP for the new subnet at the lowest cost possible. What do you recommend for adding DHCP services to the new subnet? Propose a DHCP configuration, the scope's start and end addresses, and the prefix length for the new subnet.

Answers: 3

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 23:30

The next button in the review section shows the next available comment. next slide with no comment. previous comment. edited comment.

Answers: 1

Answer

Computers and Technology, 23.06.2019 01:30

Which tab is used to change the theme of a photo album slide show? a. design b. view c. transitions d. home

Answers: 1

Answer

Computers and Technology, 23.06.2019 06:40

How many nibbles can be stored in a 16-bit word?

Answers: 1

Answer

Computers and Technology, 23.06.2019 09:30

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

Answer

You know the right answer?

CSM Tech Publishing has expanded its network from one subnet to two subnets and is putting 200 compu...

Questions