1 point
The icon in this image is most
likely a
Work Files
​

3. (6 pts) internally in the computer, with few exceptions, all numerical computation is done using binary numbers. output, however, often uses ascii, which is formed by appending 011 to the left of a bcd code. thus, an algorithm that directly converts a binary integer to a bcd integer is very useful. here is one such algorithm 1) draw lines to the left of the binary number to bound the expected bcd decades. (each decade is a group of 4 bits.) move the binary number one bit to the left. add 0011 to each bcd decade containing a binary value> 0100 repeat steps 2-3 until the last bit in the binary number has been moved into the least significant decade position. (note that when the last bit has been shifted into bcd decade, step 3 is not repeated.) read the bcd result. 2) 3) 4) 5) a) execute the algorithm for the binary number 1101101 b) execute the algorithm for the binary number 01110101110 4. (4 pts) represent the decimal number 3568 in bcd; excess-3 code; ascil; and hex.

The most common battery cable terminal is a that provides a large surface contact area with the ability to tighten the terminal onto the battery post using a nut and bolt.

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to