When you are patching a fixture in adj mydmx 3.0 you can a. Set the mode for automatic

b. You can choose the settings and it will automatically patch

c. Drag and drop it into the universe

d. You can patch any fixtures

3. (6 pts) internally in the computer, with few exceptions, all numerical computation is done using binary numbers. output, however, often uses ascii, which is formed by appending 011 to the left of a bcd code. thus, an algorithm that directly converts a binary integer to a bcd integer is very useful. here is one such algorithm 1) draw lines to the left of the binary number to bound the expected bcd decades. (each decade is a group of 4 bits.) move the binary number one bit to the left. add 0011 to each bcd decade containing a binary value> 0100 repeat steps 2-3 until the last bit in the binary number has been moved into the least significant decade position. (note that when the last bit has been shifted into bcd decade, step 3 is not repeated.) read the bcd result. 2) 3) 4) 5) a) execute the algorithm for the binary number 1101101 b) execute the algorithm for the binary number 01110101110 4. (4 pts) represent the decimal number 3568 in bcd; excess-3 code; ascil; and hex.

You need to design a circuit that implements the functions in the following table: s0 s1 function0 0 a + 10 1 a – b1 0 a + b1 1 a – 1s0 and s1 are 1-bit control inputs to select the function of the circuit. inputs a and b are 4-bitnumbers in 2s complement form. the output is also a 4-bit number in 2s complement form.you are allowed to use only one ttl 7483 4-bit adder to implement all the functions. but anynumber of other components (except the adder) can be used.hint: design a combinational logic circuit to modify the input b and the “carry input” of theadder depending on the control inputs s0 and s1.important: lab grade will depend on the working of the circuit & will be checked of by your labinstructor.1. is the output valid for the following input combinations: a. s0 = 0, s1 = 0, a = 7, b = 3? b. s0 = 0, s1 = 1, a = 7, b = 3? c. s0 = 1, s1 = 0, a = -4, b = -5? d. s0 = 1, s1 = 1, a = -8, b = 6? 2. what is the range of inputs (for both a and b) that will produce the valid output for all the functions?

1. which of the following statements are true about routers and routing on the internet. choose two answers. a. protocols ensure that a single path between two computers is established before sending packets over it. b. routers are hierarchical and the "root" router is responsible for communicating to sub-routers the best paths for them to route internet traffic. c. a packet traveling between two computers on the internet may be rerouted many times along the way or even lost or "dropped". d. routers act independently and route packets as they see fit.