Here, we investigate what happens when we change the value of a variable in a function. Your instructions are to define a function that takes a single argument, adds 10 to that argument, and then prints it out (all inside the function!) then, outside of the function, print out x, call your function using x as its argument, and print out x again In total, x should be printed out 3 times. Did you get what you expected

You need to design a circuit that implements the functions in the following table: s0 s1 function0 0 a + 10 1 a – b1 0 a + b1 1 a – 1s0 and s1 are 1-bit control inputs to select the function of the circuit. inputs a and b are 4-bitnumbers in 2s complement form. the output is also a 4-bit number in 2s complement form.you are allowed to use only one ttl 7483 4-bit adder to implement all the functions. but anynumber of other components (except the adder) can be used.hint: design a combinational logic circuit to modify the input b and the “carry input” of theadder depending on the control inputs s0 and s1.important: lab grade will depend on the working of the circuit & will be checked of by your labinstructor.1. is the output valid for the following input combinations: a. s0 = 0, s1 = 0, a = 7, b = 3? b. s0 = 0, s1 = 1, a = 7, b = 3? c. s0 = 1, s1 = 0, a = -4, b = -5? d. s0 = 1, s1 = 1, a = -8, b = 6? 2. what is the range of inputs (for both a and b) that will produce the valid output for all the functions?

You have a linux system that has a 1000gb hard disk drive, which has a 90gb partition containing an ext4 filesystem mounted to the / directory and a 4gb swap partition. currently, this linux system is only used by a few users for storing small files; however, the department manager wants to upgrade this system and use it to run a database application that will be used by 100 users. the database application and the associated data will take up over 200gb of hard disk space. in addition, these 100 users will store their personal files on the hard disk of the system. each user must have a maximum of 5gb of storage space. the department manager has made it very clear that this system must not exhibit any downtime as a result of hard disk errors. how much hard disk space will you require, and what partitions would you need to ensure that the system will perform as needed? where would these partitions be mounted? what quotas would you implement? what commands would you need to run and what entries to /etc/fstab would you need to create? justify your answers.

Read each statement below. if the statement describes a peer-to-peer network, put a p next to it. if the statement describes a server-based network, put an s next to it. p - peer-to-peer s - server-based