subject

If you were to select pin gages to check a hole with a 0.625" dia. +0.002"/-0.003", what pin sizes should be used for the go and no-go gages? Provide a three-decimal answer.

ansver
Answers: 2

Another question on Computers and Technology

question
Computers and Technology, 22.06.2019 01:00
What is added to the < meta > tag to describe the encoding type?
Answers: 1
question
Computers and Technology, 22.06.2019 21:00
Simon says is a memory game where "simon" outputs a sequence of 10 characters (r, g, b, y) and the user must repeat the sequence. create a for loop that compares the two strings starting from index 0. for each match, add one point to userscore. upon a mismatch, exit the loop using a break statement. assume simonpattern and userpattern are always the same length. ex: the following patterns yield a userscore of 4: simonpattern: rrgbryybgy userpattern: rrgbbrybgy
Answers: 2
question
Computers and Technology, 23.06.2019 09:30
The place where the extended axis of the earth would touch the celestial sphere is called the celestial
Answers: 1
question
Computers and Technology, 24.06.2019 03:30
Which explains extrinsic motivation? a)motivation in which there is a reward b)motivation that is personally satisfying c)motivation that is personally meaningful d)motivation in which the subject is interesting
Answers: 1
You know the right answer?
If you were to select pin gages to check a hole with a 0.625" dia. +0.002"/-0.003", what pin sizes s...
Questions
question
Mathematics, 12.12.2020 15:50
question
English, 12.12.2020 15:50
question
Mathematics, 12.12.2020 15:50
question
English, 12.12.2020 15:50
question
Mathematics, 12.12.2020 15:50
question
Mathematics, 12.12.2020 15:50
Questions on the website: 13722362