Computers and Technology, 02.11.2020 21:50 quickestlearner6171

Which view in the View tab of the ribbon is the easiest place to add a header or a footer? Normal view Custom Views Page Layout view Page Break Preview

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 03:30

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the â€śstub-endâ€ť fault.

Answers: 2

Answer

Computers and Technology, 22.06.2019 22:40

When you type the pwd command, you notice that your current location on the linux filesystem is the /usr/local directory. answer the following questions, assuming that your current directory is /usr/local for each question. a. which command could you use to change to the /usr directory using an absolute pathname? b. which command could you use to change to the /usr directory using a relative pathname? c. which command could you use to change to the /usr/local/share/info directory using an absolute pathname? d. which command could you use to change to the /usr/local/share/info directory using a relative pathname? e. which command could you use to change to the /etc directory using an absolute pathname? f. which command could you use to change to the /etc directory using a relative pathname?

Answers: 3

Answer

Computers and Technology, 23.06.2019 07:00

Why were most movies from the late 1890s until the early 1930s only filmed in black and white? there were only a few people who could afford the technology to produce color motion pictures back then. audiences did not want color motion pictures until later. the film used to make color motion pictures often overheated, which was a safety hazard, so it was generally not allowed. color films had to be hand-colored, frame by frame.

Answers: 3

Answer

Computers and Technology, 23.06.2019 21:30

To move a file or folder in microsoft windows, you can click and hold down the left mouse button while moving your mouse pointer to the location you want the file or folder to be, which is also known as.

Answers: 3

Answer

You know the right answer?

Which view in the View tab of the ribbon is the easiest place to add a header or a footer? Normal vi...

Questions