Sayid listed the steps for adding a recurring event in Outlook. 1: Click on Calendar in the Navigation Pane.
2: On the Home tab in the New group of the Ribbon, click New Appointment
3: Click the box for "All day event" and enter the subject.
4: Enter the details in the Recurrence dialog box and click OK.
5: Click Save & Close.
Which best describes Sayid's error?
A. For Step 1, click Appointment in the Navigation Pane.
B. For Step 2, click Recurring Appointment in the New group.
C. After Step 3, click the Recurrence button.
D. After Step 4, click the Add Appointment button.

Three out of five seniors remain undecided about a college major at the end of their senior year.

The most accurate readings that you can take on an analog vom are when the meter's pointer is at the a. center scale. b. extreme right. c. near right. d. extreme left.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."