Hey everyone so this is program basically turns the servo to 180 degrees and once it reaches there to decrement back to zero the code is here -https://hastebin. com/wuxocicula. pl and the error is there Arduino: 1.8.13 (Windows Store 1.8.42.0) (Windows 10), Board: "Arduino Uno"

The sketch name had to be modified.
Sketch names must start with a letter or number, followed by letters,
numbers, dashes, dots and underscores. Maximum length is 63 characters.

Servo_attach:2:10: error: expected initializer before 'servo'

Servo my servo;

^

C:\Users\Adithya\OneDrive\Documents \Arduino\sketch_aug10a\Fade\Servo_a ttach\Servo_attach. ino: In function 'void setup()':

Servo_attach:5:1: error: 'myservo' was not declared in this scope

myservo. attach(9);

^

C:\Users\Adithya\OneDrive\Documents \Arduino\sketch_aug10a\Fade\Servo_a ttach\Servo_attach. ino:5:1: note: suggested alternative: 'Servo'

myservo. attach(9);

^

Servo

C:\Users\Adithya\OneDrive\Documents \Arduino\sketch_aug10a\Fade\Servo_a ttach\Servo_attach. ino: In function 'void loop()':

Servo_attach:12:2: error: 'myservo' was not declared in this scope

myservo. write(pos);

^

C:\Users\Adithya\OneDrive\Documents \Arduino\sketch_aug10a\Fade\Servo_a ttach\Servo_attach. ino:12:2: note: suggested alternative: 'Servo'

myservo. write(pos);

^

Servo

Servo_attach:15:2: error: 'myservo' was not declared in this scope

myservo. write(pos)

^

C:\Users\Adithya\OneDrive\Documents \Arduino\sketch_aug10a\Fade\Servo_a ttach\Servo_attach. ino:15:2: note: suggested alternative: 'Servo'

myservo. write(pos)

^

Servo

exit status 1

expected initializer before 'servo'

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.