Draw a fourbar linkage with L1 = 10 cm, L2 = 3 cm L3 = 6 cm and L4 = 6 cm, with LaTeX: \theta_2θ 2= 45o. Consider both configurations in your drawing, namely the open and closed. Measure your transmission angles and indicate which is which. Do you see a difference in values? (0.25 point – lengths measurements)
(0.5 point – angles measurements)
(0.5 point – both configurations)
(0.5 point – neatness)
(0.5 points – links dwg)
(0.25 points – transmission angles measurements)

Ireally like network models.

Through the process of sedimentation,sediment is turned back to rock to form sedimentation.the process of sedimentation is: > deposition-where fragments were deposited into the river or sea under gravity or travelling agent such as wind or water. > sedimentation-the fragments deposited in the river sedimented and accumulate> compaction-the layers of fragments deposited undergoes compaction due to the weight if the upper layers> cementation-chemical substance of the fragments such as cement dissolved into the water and cement the other fragments together to form sedimentary rock.thus,cementation and compaction are the process.on the other hand, transformation only occur when a rock under goes metamorphism(compaction or extreme heat).while recrystillization occurs when a rock is melted and cooled down,which also requires metamorphism to take place.hope it !