A large firm allocates its accounting duties to a small organization that specializes in the accounting field. Which data-management technique does the firm use? The large firm uses the
data-management technique.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Technician a says that with self-adjusting clutch systems, the release bearing constantly rotates. technician b says that the ball bearing portion of the release bearing should be lubricated with high-temperature grease during routine maintenance. which technician is correct?

1. which of the following statements are true about routers and routing on the internet. choose two answers. a. protocols ensure that a single path between two computers is established before sending packets over it. b. routers are hierarchical and the "root" router is responsible for communicating to sub-routers the best paths for them to route internet traffic. c. a packet traveling between two computers on the internet may be rerouted many times along the way or even lost or "dropped". d. routers act independently and route packets as they see fit.