Computers and Technology, 28.05.2020 03:58 toyensianelys130

Write a complete program in Assembly Language: 1. Promts the user to enter 10 numbers. 2. saves those numbers in a 32 bit integer array. 3. Calculates the sum of the numbers and displays it. 4. Calcualtes the mean of the array and displays it. 5. Prints the array with the same order it was enterd. 6. Rotates the members in the array forward one position for 9 times. so the last rotation will display the array in reversed order. Print the array after each rotation. check the sample run. Here is Sample Run: Please enter a number: 2 Please enter a number: 3 Please enter a number: 4 Please enter a number: 5 Please enter a number: 6 Please enter a number: 7 Please enter a number: 8 Please enter a number: 9 Please enter a number: 0 Please enter a number: 10 The sum is: 54 The mean is: 5 4/10 The original array: 2 3 4 5 6 7 8 9 0 10 After a rotation: 10 2 3 4 5 6 7 8 9 0 After a rotation: 10 0 2 3 4 5 6 7 8 9 After a rotation: 10 0 9 2 3 4 5 6 7 8 After a rotation: 10 0 9 8 2 3 4 5 6 7 After a rotation: 10 0 9 8 7 2 3 4 5 6 After a rotation: 10 0 9 8 7 6 2 3 4 5 After a rotation: 10 0 9 8 7 6 5 2 3 4 After a rotation: 10 0 9 8 7 6 5 4 2 3 After a rotation: 10 0 9 8 7 6 5 4 3 2 Press any key to continue . . .

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 21.06.2019 17:00

How should you set the ohms adjust control on a multitester of analog vom, for resistance measurements?

Answers: 1

Answer

Computers and Technology, 23.06.2019 09:30

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

Answer

Computers and Technology, 23.06.2019 14:00

Need ! will choose brainliest! discuss the role of abstraction in the history of computer software.

Answers: 1

Answer

Computers and Technology, 23.06.2019 15:30

The song about casey jones a railroad engineer who gives his life on the job would most likely gall under the folk song category of? a-work song b-nonsense song c-religious song d-ballad

Answers: 1

Answer

You know the right answer?

Write a complete program in Assembly Language: 1. Promts the user to enter 10 numbers. 2. saves thos...

Questions