Define stubs for the functions get_user_num() and compute_avg(). Each stub should print "FIXME: Finish function_name()" followed by a newline, and should return -1. Each stub must also contain the function's parameters.

Sample output with two calls to get_user_num() and one call to compute_avg():

FIXME: Finish get_user_num()

FIXME: Finish get_user_num()

FIXME: Finish compute_avg()

Avg: -1

code to fill in:

''' Your solution goes here '''

user_num1 = 0

user_num2 = 0

avg_result = 0

user_num1 = get_user_num()

user_num2 = get_user_num()

avg_result = compute_avg(user_num1, user_num2)

print('Avg:', avg_result)

Write a function named printfloatrepresentation(float number) that will print the floating point representation of a number using the format given below. (sign bit) exponent in binary (assumed bit).significandfor example if the number passed an argument is 71 yourprogram should print (0) 10000101 (1).00011100000000000000000similarly if the number passed to the function as argument is -71 the program should print (1) 10000101 (1).00011100000000000000000

When you type the pwd command, you notice that your current location on the linux filesystem is the /usr/local directory. answer the following questions, assuming that your current directory is /usr/local for each question. a. which command could you use to change to the /usr directory using an absolute pathname? b. which command could you use to change to the /usr directory using a relative pathname? c. which command could you use to change to the /usr/local/share/info directory using an absolute pathname? d. which command could you use to change to the /usr/local/share/info directory using a relative pathname? e. which command could you use to change to the /etc directory using an absolute pathname? f. which command could you use to change to the /etc directory using a relative pathname?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.