According to the Surgeon General: "Strength-developing activities (resistance training) should be performed at least times per week. At least 8-10 strength-developing exercises that use the major muscle groups of the legs, trunk, arms and shoulders should be performed at each session, with one or two sets of 8-12 repetitions of each exercise."

4.11 painting a wall (1) prompt the user to input integers for a wall's height and width. calculate and output the wall's area (integer). note that in this case there is a new line after each prompt. (submit for 1 point). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet (2) extend to also calculate and output the amount of paint in gallons needed to paint the wall (floating point). assume a gallon of paint covers 350 square feet. store this value in a variable. output the amount of paint needed using the %f conversion specifier. (submit for 2 points, so 3 points total). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet paint needed: 0.471429 gallons (3) extend to also calculate and output the number of 1 gallon cans needed to paint the wall. hint: use a math function to round up to the nearest gallon. (submit for 2 points, so 5 points total). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet paint needed: 0.471429 gallons

Which of the following had the greatest influence on opening the internet to the generly public

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.