Computers and Technology, 02.03.2020 18:12 maxgeacryne5573

A certain program takes 26.67 seconds to run on 3 processors and 16 s to run on 7 processors. Find the execution time on one processor, the fraction of the program that can be parallelized, the theoretical execution time on an infinite number of processors, and P1/2.

Answers: 2

Show answers

Answers

Answer from: mikayla62

The explanation for the question is listed in the section below on Explanation.

Explanation:

The time needed for a program to execute in 26.67 seconds on 3 processors. Time expected to run the program, therefore, should be as follows:

The time to run on one processor = $\frac{26.67}{3}$ = 8.89 seconds.

The time needed for a program to execute in 26.67 seconds on 7 processors, should be:

Time = $\frac{16}{7}$ = 2.2857 seconds.

Whenever the amount of processors increases the performance or speed should increase.

The time is taken in percentage = $\frac{26.67}{16}$ ×100% = 170 %

As the number of processors increases from 3 to 7, the time required according to each processor increases by 70%.

In one processor the execution time should be as follows:

26.67+(26.67×0.7) = 45.339

= 45 seconds

Therefore. the execution period for a single processor is about 45 seconds.

The work is performed in parallel, whereas the program is already being parallelized. The overall function ought to be shared between the processor. The time is shortened to around half. Hence the duration taken will be 8 seconds after parallelization.

Theoretical execution time would be Tp > T infinity.

Thus, T infinity<45

The theoretical processing interval on processor count P1/2 would therefore be less than 8 seconds. Because, the time required during parallelization was just that.

Answer from: Quest

Ithink the answer is a.

Answer from: Quest

Imean it could be either both i get why it could be part of being human because some people just look at the famous people and they probably think to themselves that if that person does that well then i should do it and maybe i’ll get the attention and followers that i want. it could be also connected to the current young phenomenon because some kids at the age of 14 are already famous like for doing the most nasty things probably without even thinking who would probably watch such thing, they just do it cause they know they’ll get the attention that they want. sorry if i didn’t use correct grammar.but hope this answers the question< 3

Another question on Computers and Technology

Computers and Technology, 22.06.2019 11:10

The total cost of textbooks for the term was collected from 36 students. create a histogram for this data. $140 $160 $160 $165 $180 $220 $235 $240 $250 $260 $280 $285 $285 $285 $290 $300 $300 $305 $310 $310 $315 $315 $320 $320 $330 $340 $345 $350 $355 $360 $360 $380 $395 $420 $460 $460

Answers: 2

Answer

Computers and Technology, 22.06.2019 18:30

Which of the following commands is more recommended while creating a bot?

Answers: 1

Answer

Computers and Technology, 22.06.2019 19:30

The following is an excerpt from a slide presentation. today we will inverse operations solving equations using inverse operations solving inequalities using inverse operations from which part of the presentation does the slide most likely come from? a. introduction b. outline c. body d. conclusion

Answers: 1

Answer

Computers and Technology, 23.06.2019 01:50

Write a program that uses a random number generator to generate a two digit positive integer and allows the user to perform one or more of the following operations: a. double the number. b. reverse the digits of the number. c. raise the number to the power of 2, 3, or 4. d. sum the digits of the number. e. if the number is a two-digit number, then raise the first digit to the power of the second digit. f. if the number is a three-digit number and the last digit is less than or equal to 4, then raise the first two digits to the power of the last digit. after performing an operation if the number is less than 10, add 10 to the number. also, after each operation determine if the number is prime. each successive operation should be performed on the number generated by the last operation. your program should not contain any global variables and each of these operations must be implemented by a separate function. also, your program should be menu driven. 7. (fraction calculator) write a program that

Answers: 1

Answer

You know the right answer?

A certain program takes 26.67 seconds to run on 3 processors and 16 s to run on 7 processors. Find t...

Questions