The number of semi skilled workers in an industry find themselves out of work, when improvements in technology render their jobs obsolete these workers experience?

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Businesses allocate resources for their best and most productive uses. the more a resource, the more costly it will be. a manufacturer that requires scarce and costly resources is likely to charge for its products.

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.