Alarge corporation owning ip address range of 192.168.2.0/25 has its own isp. assume that an office building within the corporation using address range of 192.168.2.0/28 desires a connection with its own autonomous isp in addition to the connection with its corporation. the building is connected to corporation edge router r1 through its edge router r2, and is also connected to its own isp through r3. we would like to configure connecting routers according to bgp. (a) show the configuration of r1 and r2 and specifically demonstrate what r1 and r2 should advertise. (b) repeat part (a) when the building management decides to have its own independent network ip addresses. (c) show how routers should be configured if the corporation decides to use the building’s isp when it experiences slow bit rates during the peak traffic times.

Write a program to analyze student’s scores. each student’s id and 4 original test scores are saved in the attached file “student_id_scores.txt”. assume there are exactly 15 students in the class.• the program first opens the file, reads student’s ids and scores from the file and saves them in two arrays: o create a one-dimensional string array “ids” to store the student’s ids.o create a (parallel) two-dimensional int array “scores” to store student’s original test scores. this array has 5 columns, the original 4 test scores should be saved in the first 4 columns, and the last column will be used to save the average score after the calculation in next step.• the program then retrieves test scores from the array “scores”, calculates average score and determines the final letter grade based on the rules in the table below for each student. assume average score is integer value.average score = (score1 + score2 + score3 + score4) / 4average score letter grade90 ~ 100 a80 ~ 89 b70 ~ 79 c60 ~ 70 d0 ~ 60 f• the average score should be saved back in the 5th column of “scores” array.• create a new parallel one-dimensional char array “grades” to save each student’s letter grade.• program also needs to find the number of a, number of b, number of c, number of d and number of f grade. as well as the highest, lowest and average score of the class.• finally, program will display all of the original scores and all results on the computer screen using the format shown as the sample output below.• the program must contain at least the following functions: (1) a function “getscores” to read and store data into “ids” and “scores” arrays.(2) a function “analyzescores” to calculate student’s average score, determine letter grade, get the number of a, b, c, d and f, find the highest, lowest and average score of the class.(3) a function “displayresults” to display all of the results