Next, sort the traced packets according to ip source address by clicking on the source column header; a small downward pointing arrow should appear next to the word source. if the arrow points up, click on the source column header again. select the first icmp echo request message sent by the client computer, and expand the internet protocol portion in the "details of selected packet header" window. in the "listing of captured packets" window, you should see all of the subsequent icmp messages (perhaps with additional interspersed packets sent by other protocols running on the computer) below this first icmp. use the down arrow to move through the icmp messages sent by the computer.

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to